Alright, let’s talk about this galvalume metal siding, ya know, the stuff they put on houses and barns and such.
First off, what is it? Well, it’s like that ol’ galvanized steel, but a bit fancier. They say it’s got some kinda special coating to keep it from rusting. Keeps the rain and snow out, and the bugs too, I reckon. Folks been usin’ somethin’ like it for ages, like on them old barns way back when. This new stuff, though, it’s supposed to last longer and look prettier, they say.
Now, puttin’ it up ain’t always as easy as pie, but it ain’t rocket science neither. You gotta have somethin’ underneath it, they call it an “underlayment”. Sounds fancy, but it’s just like a thin blanket to keep the water out. Gotta make sure it’s the kind that lets the air move around a bit, so things don’t get all damp and moldy underneath. You just staple it on, easy peasy.
- Important thing number one: Get that underlayment right. Don’t skimp on it, or you’ll be sorry later.
- Important thing number two: They say puttin’ it up and down is better than sideways. Makes it easier to clean, and less likely to get messed up, I guess. Makes sense, things don’t sit on it as easy if it’s straight up and down, water runs off better too.
When you’re puttin’ them metal sheets up, you gotta make sure they overlap, ya know, like shingles on a roof, but bigger. Measure real good and mark where they should go, so you don’t end up with gaps. Use a pencil or somethin’, not your finger, ha! Then when you put ‘em up, make sure they fit tight together. Don’t want no wind or rain sneakin’ in.
They say this metal siding is good ‘cause it lasts a long time, keeps the weather out real good, looks nice, and don’t cost an arm and a leg. Well, that’s what they say, anyway. I reckon it depends on who’s doin’ the work and what kinda metal you get. Some of that stuff is thin as paper, wouldn’t trust it to keep a chicken coop dry.
Cutin’ the metal, now that’s somethin’ you gotta be careful with. Don’t go usin’ your grandma’s good scissors! They got special tools for that, shears and such. And you gotta measure twice, cut once, like they say. Don’t wanna waste good metal, that stuff ain’t cheap.
They got books and stuff that tell you how to put it up, step by step. Probably got videos on that internet thing too. My grandkids are always watchin’ stuff on there. If you ain’t sure, ask someone who knows. Better to ask a dumb question than make a dumb mistake, that’s what my old pappy used to say.
So, is this galvalume metal sidin’ worth it? Well, I reckon it can be. If you do it right, and you get good metal, it’ll last ya a long time and keep your place lookin’ decent. Just don’t go rushin’ into it. Take your time, do it right, and you’ll be just fine.
And remember, keep that water out, that’s the main thing. Nothin’ worse than a leaky house. Makes everything damp and smelly, and then you got bigger problems than just some ugly siding.
So, there you have it. That’s about all I know about this galvalume stuff. Hope it helps ya out some.
Tags: [galvalume metal siding, metal siding installation, metal siding, steel siding, siding, exterior siding, home improvement]
